Table of Contents
Advertisement
Slide the battery compartment
cover in the direction of the
arrow.
Install two "AAA" batteries
,_
Replace the compartment
(supplied), paying attention to the
,_
cover.
polarity diagram in the battery
compartment.
a
€
O
Battery precautions
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re-
versed batteries may cause damage to the device. To avoid a potential short circuit, insert the "-" end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. ]f the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. De not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer's directions.)
• Press POWER (V_O) to turn the DVD VCR on or off.
• Select your desired operating mode (DVD or VCR) using VCR DVD.
(DVD or VCR indicator on the front panel will show you which mode is selected.)
• Press OH + or OH - to move through the channels one channel at a time.
• The CH +/- ( • / •)
and SET +1- (AI V) are also used to navigate on-screen menu system.
• You can directly access specific channels using Number buttons.
• Each press ofVCR DVD on the remote control, switches the screen between the VCR screen (VCR mode) and the
DVD screen (DVD mode).
Operation
o_o
_
• Aim the remote control at the remote sensor and press control buttons to
°°°
operate.
_
-_=J ]'
• Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of Approx. 7 meters.
_
Approx. 7 meters
131
Advertisement
Table of Contents
