Securing The Cables; Securing Cables At The Ifp; Securing Cables At The Transceiver Unit; Securing Cables For Use In Hazardous Areas - Siemens SIMATIC IFP1200 V2 Product Information

Installing and connecting the device
3.4 Connecting the device
3.4.7

Securing the cables

3.4.7.1

Securing cables at the IFP

Use cable ties to secure the connected cables to the strain relief plate:
Make sure that the cables are not crushed by the cable tie.
Possible fastening points are marked in the following figures.
The following figure shows an example of securing the cables to the strain relief plate of a
built-in device.
3.4.7.2

Securing cables at the Transceiver Unit

The USB cable and the power supply cables connected to the Transceiver Unit must be
secured using the supplied strain relief elements.
To install the strain relief elements and secure the cables, proceed as follows:
1. Hang the strain relief elements
from the scope of delivery at
an angle of approx. 60° to the
vertical from below into the
corresponding opening in the
enclosure of the
Transceiver Unit.
2. Swivel the strain relief element
into the vertical position.
3. Secure the power supply
cables and the USB cable with
cable ties on the respective
strain relief element.
Make sure that the cables are
not crushed by the cable tie.
3.4.7.3

Securing cables for use in hazardous areas

Secure the IFP cables to the strain relief plate and the Transceiver Unit cables to the strain
relief elements as described in the previous section.
36
IFP V2 built-in devices and Transceiver Unit UL hazardous information
Product Information, 12/2023, A5E53493649-AA