Advertisement
OPERATION CHECK-3
1.OPERATION CHECK(3/3)
b. OPERATIONS OF VIDEO SIGNAL-DETECTION
1. Confirm "RDS" light up on FL TUBE when component video signal is input in "TEST 5-00".
Confirm "RDS" turn off on FL TUBE when component video signal isn't input in "TEST 5-00",too.
2. Confirm "FM STEREO" light up on FL TUBE when component video signal is input in "TEST 5-00".
Confirm "FM STEREO" turn off on FL TUBE when component video signal isn't input in "TEST 5-00",too.
1-11. CONFIRMATION OF 12V TRIGGER OPERATIONS(TX-NR828,DTR-30.5/40.5/50.5 ONLY)
See "OPERATION CHECK-4, -5" for TEST MODE operation.
a. After checking that there is no output from 12V TRIGGER A terminal,it checks that there is an output of 12V±10%/150mA
after switched the "TEST2-11".
b. After checking that there is no output from 12V TRIGGER B terminal,it checks that there is an output of 12V±10%/25mA
after about 1 seconds switched the "TEST2-12". (DTR-30.5/40.5/50.5 ONLY)
c. After checking that there is no output from 12V TRIGGER C terminal,it checks that there is an output of 12V±10%/25mA
after 2 seconds switched the "TEST2-13". (DTR-30.5/40.5/50.5 ONLY)
1-12. CONFIRMATION OF COOLING FAN OPERATION
See "OPERATION CHECK-4,-6" for TEST MODE operation.
a. Confirm to fan no rotate.
b. When TEST 4-36 or TEST 4-37, confirm to fan rotate.
1-13. CONFIRMATION OF Wi-Fi CONNECTION
a. After setting wifi routers, change the state to "IDLING TIMER MODE".
See "OPERATION CHECK-4, -6" for TEST MODE operation.
b. It connects an access point automatically. Wi-Fi LED flashes during connection.
c. When connection is completed and IP address is able to be acquired, Wi-Fi LED lights up and the value of RSSI
to an access point is displayed per dbm.
If the connection failed, NG is displayed.
* If the connection failed, exit the idle mode by pressing the TV/CD button and please try again from [a].
SSID No
1-14. MISCELLANEOUS
a. Confirm all input and output terminals operate normally.
b. Please confirm LED and FL displaying by the FL test mode. And confirm the destination setting.
---> See to "OPERATION CHECK-4" for TEST MODE operation.
c. Change the state to KEY TEST under TEST MODE described in Section 2-2. to confirm each key operation.
---> See to "OPERATION CHECK-4" for TEST MODE operation.
d. Confirm the version of each firmware.---> See to "SERVICE PROCEDURE-2"
e. Confirm the firmware combination check.---> See to "OPERATION CHECK-4" for TEST MODE operation.
f. CPlease confirm the Check Sum.---> See to "OPERATION CHECK-4" for TEST MODE operation.
TX-NR626/727/828/ HT-RC560/ DTR-30.5/40.5/50.5
1
-45d
00:10:00
RSSI(dbm)
Time Counter
Advertisement
