Table of Contents
Advertisement
ens
oer sone
wt aetilglate
ee
Sone
Se nT
Aye Sate:
Operation
Seeing TV Program
isn
mee
5 'il
Fs
Press POWER to turn on the TV.
If the "VIDEO 1", "VIDEO 2", "WADEO 3", or "EXT-A"
indication is displayed on the screen, press the TV
button on the Remote Commander so that a channel
number is displayed.
:
Set the CABLE selector
For VHF and UHF channels : OFF
For cable TV programs
: ON
Press the ANT/AUX button as necessary.
For VHF, UHF and regular cable TV channels: the
"AUX" indication should be off.
For pay cable TV channels: the indication should be
displayed.
Select channels in one of the following two ways.
¢ Press the numeral(s) of the channel, then press
ENTER.
Example: To select channel 6, press 6 and ENTER.
To select channel 125, press 1, 2, 5 and
ENTER.
If you pressed a wrong numeral, wait for a few
seconds until it disappears. Then, try again.
e Press CH or CHANNEL "+" for higher-numbered
channels and "—" for lower-numbered channels.
Press VOL or VOLUME "+" or "—" to adjust the volume
and PICTURE "+" or "—" to adjust the picture.
MUTING button
JUMP button
To mute the sound, press MUTING.
The "MUTING" indication will appear on the screen. To
restore the sound, press MUTING again or VOL +/-.
To turn off the unit, press POWER again.
Advertisement
Table of Contents
