Table of Contents
Advertisement
Chapter 3: PC Installation
This chapter describes how you can connect and use the PowerLook 1120 scanner with your IBM PC
or compatible computer.
Installing the Software
Install the software in two easy steps, in the following order:
1.
Image Application Software, e.g. Adobe PhotoShop.
2.
Then MagicScan.
3.
Then binuscan PhotoPerfect if needed.
Notes: If installation program does not show up automatically, please follow the procedure to install:
Choose RUN from Start menu and type d:\setup (where "d" indicates CD-ROM drive), then click OK.
Double-click the ReadMe icon in the MagicScan group for important up-to-date information that
may not be included in the manual. If there are any problems with the icons in MagicScan group,
double-click the Help icon in the MagicScan group.
MagicScan is the interface used by application software to control UMAX scanners. Its advanced
controls allow precise adjustments in images even during the initial scan.
For detailed information on installing the image editing application software, refer to the Installation
section of the Image Editing Application Software User's Guide.
Connect the Scanner to the Computer
With settings on the scanner and card correctly set and the interface card properly installed in your
computer, you can now connect the scanner and the computer, as follows:
1.
Connect the IEEE 1394 cable connector to the interface card in the PC.
2.
Connect the other end of the IEEE 1394 cable to the scanner.
3.
Connect the power cord to the scanner.
4.
Turn on the scanner power.
5.
Turn on the computer power.
Hardware installation is now completed. Get ready to run the UMAX Setup program to install the
supporting UMAX software supplied with your system.
10
Advertisement
Table of Contents
