Table of Contents
Advertisement
Section 7
Storage
When storing the unit for more than 30
days:
Add a gasoline stabilizer to fuel and
follow instructions provided with
stabilizer. Or, move unit outside and
run engine until it stops from lack of
fuel. See engine manual for other
engine-related storage procedures.
Remove key from ignition.
Lower any mounted attachment to
ground. Place attachment/PTO switch
into the "OFF" position.
Allow engine to cool and clean dirt and
debris from unit. Thoroughly clean
engine cooling fins, engine flywheel
screen and transmission cooling fins.
Change engine oil.
Remove, clean and re-gap spark plug.
Reset gap according to specifications in
engine manual.
Re-install spark plug. Replace plug if
badly worn. Leave spark plug wire
disconnected.
Clean or replace engine air filter (on
units so equipped) if necessary.
Check fuel filter and replace if
necessary.
Charge battery at 6-10 amps for 1 hour
before storage. Store battery at 20° F
(7°C) to 50° F(10°C). Clean battery
posts and coat with petroleum jelly.
Apply rust preventative to surfaces
subject to corrosion.
Apply touch-up paint to surfaces where
paint has chipped.
Apply a good grade of automotive wax to
hood.
Store unit in a dry, secure location.
33
Advertisement
Table of Contents
