Playing Back Tapes (On Either Deck A Of B) - Sony SEN-231CD Operating Instructions Manual

Playing Back Tapes (on either Deck A or B)
This section describes about a basic playback operation on
either deck A or B.
eo 0
—o——|—1@i-F} i—i@l—|—
—_
2 Open the cassette compartment and insert the
tape with the side to be played back facing you.
10
Ae 9S dR OO
3 Press TAPE SELECTOR to select the tape type.
TAPE SELECTOR
a TYPE I! 0 TYPE1
4 Press DOLBY NR to select the DOLBY NR
setting.
DOLBY NR
sON OOFF
5 Press > to start playback.
When the tape ends, playback automatically stops.
To stop playback, rewind or fast forward, press w &.
To pause, press U1.
To resume playback, press tt again.
To rewind the tape, press <<.
To fast-forward the tape, press >>.
Notes
¢ When both decks A and B are in playback mode, only
playback from deck A will be audible.
¢ During playback or recording on a deck, do not operate
the other deck.
¢ Before turning the power off, be sure to release > or @ by
pressing m@ &. Otherwise, the tape may become
entangled when the power is turned on again.
What is the Dolby NR* system?
Dolby NR (noise reduction) system reduces tape hiss noise
in low-level, high-frequency signals. The system boosts
these signals in recording and lowers them in playback.
When listening to a tape recorded with Dolby NR, set the
DOLBY NR switch to ON.
* Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation.
"DOLBY" and the double-D symbol 00 are trademarks of Dolby
Laboratories Licensing Corporation.