Table of Contents
Advertisement
-
II ■
-
··-
END Point lever
This lever sets the end-point of the
sampled sound.
START /SPLICE Lever
This lever sets the start/splice point
of the sampled sound
.
Note:
Normally,
this lever sets the
starting point
.
However,
when the MANUAL SPLICE
button is pressed, it will set
the splicing point.
ALTERNATING Button
Press this button to set the scanning
mode to
alternating.
The LED indica-
tor will light.
-
-
LIO
~
~
TART/SPLICE
SPl :EO
DEl 'TH
:(~5).:
:((2):
LOW
HIGH
MIN
MA
X
::,
§
OUTPUT
J
FILTER
OECAY
T
-
J
~
s
LOW
HIGH
0
10
-
-
DEi AV
MANUAL SPLICE Button
Press this button to set a splicing
point
manually.
The LED indicator will
light.
LFO,
SPEED, DEPTH, DELAY controls
A vibrato effect can be added to the
sampled sound by using the LFO
.
SPEED - Adjusts the speed of the vi-
brato.
DEPTH - Adjusts the depth of the vi-
brato.
DELAY - Adjust the delay time of the
vibrato.
-
TUNE
~
.
..
'
.
0
10
LEVEL
LINE OUT
@
I
,o
-
' - - - - - - - - - - - - - - - - - - - - - KEY TRANS Button
Press this button to transpose the
sampled sound
.
The LED indicator
will light.
' - - - - - - - - - - - - - - - - - - - - - - - MIDI CHANNEL UP Button
- - - - - MIDI CHANNEL DOWN Button
Press this button to lower the MIDI
channel number.
•
Pressing once decreases the
channel by one
.
Pressing the
button while "O
"
is displayed on
the MIDI CH
.
display will revert the
display to
"9".
-----VERIFY Button
Press this button to verify the sound
data saved on disk.
Press this button to increment the
MIDI channel number.
•
Pressing once increass the chan-
nel by one. Pressing the button
while "9" is displayed on the MIDI
CH
.
display wi ll forward the dis-
play to "O".
LOAD Button
Press this button to load the sound
data, saved on
disk,
into the S612.
4v
TUNE Control
The sampled sound can be fine tuned
using this control. It will also serve as
a pitch control when replaying
sampled sound.
LINE OUT Jack
The monitor/output signal of the
S61 2 appears at this LINE OUT jack,
which can be connected to the line
input of mixers or
amplifiers.
•
Connect a standard 6 .3 mm¢
phone plug to this jack.
Note:
This jack is connected in paral-
lel with the LINE OUT jack on
the rear panel.
LEVEL Control
This control adjusts the output level
of the sampled sound
.
The monitor
level is not affected by the output
LEVEL control.
DECAY Control
This control adjusts the decay efect
of the sampled sound
.
Turning the
knob clockwise will increase the
decay time after
key-off.
FILTER Control
This control adjusts the low-pass
fHtering on the sampled
sound.
The
replayed sampled sound will become
mellower as the control is turned to-
wards the LOW
position.
Advertisement
Table of Contents
