Dell D13U Service Manual page 9

c. Align the power button on the device with the slot on the stand back cover chassis.
d. Press the device until the retention latch clicks into place and secures it.
e. Connect the keyboard, mouse, network, power, and display cable to the device.
CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into
the device.
f. Slide the back cover, along with the device, into the stand until it clicks into place.
g. Lock the stand cover.
Installing the device on offset VESA mount:
a. Align the screw holes on the device to the screw holes on the offset VESA mount.
b. Install the four screws to secure the device to the offset VESA mount.
c. Align the screw holes in the offset VESA mount with the screw holes on the back cover of the monitor.
d. Install the four screws to secure the offset VESA mount to the monitor.
e. Align the tabs on the adapter that is attached to the stand, with the slots on the back of the monitor.
f. Slide the tabs on the stand adapter into its slots on the monitor.
g. Connect the keyboard, mouse, network, power, and display cable to the device.
CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into
the device.
Installing the device on Pro 2.0 Height-adjustable stand:
a. Press the button on the side of the stand chassis, to release the stand cover.
b. Slide and release the inner bar on the lower edge of the stand cover.
c. Align the vents on the device with the vents on the stand cover and slide the device in the cover.
d. Slide the inner bar back to the lower edge of the stand cover to lock the device to the cover.
e. Connect the keyboard, mouse, network, power, and display cable to the device.
CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into
the device.
f. Slide the back cover, along with the device, into the stand until it clicks into place.
g. Lock the stand cover.
Installing the device on Wall Mount:
a. For full function wall mount:
i. Align the screw holes on the device with the screw holes on the wall mount bracket.
ii. Install the four screws to secure the device to the wall mount bracket.
iii. Insert the hooks on the mounting bracket of the wall mount into the slots on the wall mount bracket module.
iv. Align and insert the hooks on the wall mount bracket module into the slots on the wall mount until it clicks into place.
v. Connect the keyboard, mouse, network, power, and display cable to the device.
CAUTION:
into the device.
vi. Close the stand cover.
vii. Lock the device and the stand cover.
b. For simple function wall mount:
i. Align the screw holes on the device with the screw holes on the wall mount bracket.
ii. Install the four screws to secure the device to the wall mount bracket.
iii. Connect the keyboard, mouse, network, power, and display cable to the device.
CAUTION:
into the device.
iv. Align and mount the wall mount bracket module in the screws on the wall.
2. Turn on your device.
3. If required, verify that the device works correctly by running ePSA diagnostics.
To connect a network cable, first plug the cable into the network device and then plug it
To connect a network cable, first plug the cable into the network device and then plug it
Working on your computer 9