Table of Contents
Advertisement
8 Level the Unit
Leveling Information
IMPORTANT
It is extremely important that the unit sits on a level
surface, as it does not have feet levelers. If it is not level,
the ice mold will not fill evenly.
Use a level to check the
levelness of the unit from
front to back and from side
to side. Level should be
placed along top edge and
side edge as shown (see
Figure 22). Go on to
9 Install the Unit.
www.U-LineService.com
WH95TP, BI95BTP and BCM95 Ice Makers
Figure 22
9 Install the Unit
Installation of the WH95TP, BI95BTP
or BCM95
1. Open the water supply valve in the main water source.
2. Plug in the power cord.
3. Gently push the unit into position. Be careful not to
kink the water supply line or entangle the electrical
cord.
4. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" below the
countertop.
5. Secure the flange to the frame structure using the four
holes in the flange. The type of fasteners will depend
on the structure you are mounting the flange to.
Grille Installation
1. Locate and remove the grille screw from the cabinet,
using a standard blade screwdriver (or a 1/4"
nutdriver). See Figure 23.
Figure 23
2. Identify the grille screw hole on the grille itself. It is
located toward the top of the middle recessed section
of the grille.
3. Place the two hook-hinges (located on the rear bottom
side of the grille) onto the front lip of the unit base.
Swing the grille up into position, aligning the grille
screw hole on the grille to the grille screw hole on the
cabinet. See Figure 24.
10
Grille Screw
02/2005
Hide quick links:
Advertisement
Table of Contents
