Shure BLX4R User Manual page 8

Hide thumbs Also See for BLX4R:
Table of Contents

Advertisement

Single System Set Up
Before you begin, turn off all transmitters and turn on any equipment
(other microphones or personal monitoring systems) that could cause
interference
during the performance.
1. Press and release the
group
button on the receiver.
The receiver scans for the clearest group and channel.
Note; If you want to stop the scan, push the
group
button again
.
2. Turn on transmitter and change the group and channel to match the
receiver (See Setting Transmitter Group and Channel).
Once the system is set up, perform an audio check and adjust the gain
if
necessary.
Multiple System Set Up
Up to 12 systems can operate simultaneously (band and RF environment
dependent).
Important: Set up each system one-at-a-time. Once a receiver and
transmitter are tuned to the same group and channel, leave the transmitter
powered on. Otherwise, scans from the other receivers will not detect that
channel as occupied.
Turn on any other equipment that could cause interference during the
performance so it will be detected during the group and channel scans in
the following steps.
Before you begin system set up, turn all receivers ON and all transmitters
OFF.
For the first receiver:
1. Perform a group scan to find the group with the most clear
channels.
2. Turn on the first transmitter and change the group and channel to match
the receiver.
3. Leave the transmitter on and continue with the additional systems.
Note: If the selected group does not contain enough open channels,
manually select group "d" when setting up larger systems.
For each additional receiver:
1. Manually change the receiver to match the group setting of the first
receiver. Recall that each time the group setting is changed, a channel
scan is automatically done.
2. Turn on the transmitter and change the group and channel to match the
receiver.
3. Leave the transmitter on and continue to the next system.
4. Once all receivers are set up, perform an audio check on all
microphones.
Setting Transmitter Group and Channel
Transmitter group and channel must be manually set to match the
receiver.
Group (letter)
1
.
Press and release the
group
button on the transmitter to activate the
display. Press the
group
button again and the display flashes.
·
2.
While the display is flashing, press the
group
button again to advance
to the desired group setting.
Channel (number)
If channel needs to be changed, follow the same procedure using the
channel
button instead of the
group
button.
Note:
• When the group and channel correctly match the
receiver,
the RF bars
and battery LED on the receiver illuminate.
• After manual setup, the transmitter alternately displays the group and
channel setting for about two seconds.
[ffi
I
[I]
group
channel
r
7
1
w
g,oup/
((!)
1
x2
2
~
Manually Setting Receiver Group and
Channel
The receiver group may need to be changed as part of a multiple system
setup.
Group (letter)
1. Hold the
group
button on the receiver until the display begins to flash.
2. While the display is flashing, press the
group
button again to advance
to the next
group.
Note; Only the group setting will be displayed during the manual
setup.
3. Once the desired group is reached, release the
group
button. The
receiver automatically performs a channel scan.
Channel (number)
Always use a channel selected by the channel scan. Ho:,yever, if
necessary, the channel can be set manually. Follow the same steps above
using the
channel
button
instead
of the
group
button.
9

Advertisement

Table of Contents
loading

Table of Contents