Licensing Information - Shure BLX4R User Manual

14
Certifications
BLX1,BLX2,BLX4R
Meets requirements of the following standards: EN 300 422 Parts 1 and 2,
EN 301 489 Parts 1 and 9, EN60065.
Meets essential requirements of the following European Directives:
• R&TTE Directive 99/5/EC
• WEEE Directive 2002/96/EC, as amended by 2008/34/EC
RoHS Directive 2002/95/EC, as amended by 2008/35/EC
Note: Please follow your regional recycling scheme for batteries and electronic
waste
BLX4R
Approved under the Declaration of Conformity (DoC) provision of FCC
Part 15.
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/
NMB-3(B)
BLX1,BLX2
Certified under FCC Part 74.
Certified by IC in Canada under RSS-123 and RSS-102.
FCCID:DD4BLX1A,DD4BLX1B,DD4BLX1C,DD4BLX1D;DD4BLX2A,
DD4BLX2B, DD4BLX2C, DD4BLX2D, DD4BLX1 W, DD4BLX1 S,
DD4BLX2W, DD4BLX2S. IC: 616A-BLX1 A, 616A-BLX1 B, 616A-BLX1 C,
616A-BLX1D;616A-BLX2A,616A-BLX2B,616A-BLX2C,616A-BLX2D
Certified by IC in Canada under RSS-102 and RSS-210.
IC: 616A-BLX1 W, 616A-BLX1 S, 616A-BLX2W, 616A-BLX2S
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation of this device is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause
undesired operation of the device.
Le present appareil est conforme aux CNR d'lndustrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisee aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioelectrique subi, meme si le brouillage est susceptible d'en
compromettre le fonctionnement.
This device operates on a no-protection no-interference basis. Should
the user seek to obtain protection from other radio services operating in
the same TV bands, a radio licence is required. Please consult Industry
Canada's document CPC-2-1-28, Optional Licensing for Low-Power Radio
Apparatus in the TV Bands, for details.
The CE Declaration of Conformity can be obtained from Shure
Incorporated or any of its European representatives. For contact
information please visit www.shure.com
The CE Declaration of Conformity can be obtained from: www.shure.com/
europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: info@shure.de
LICENSING INFORMATION
Licensing: A ministerial license to operate this equipment may be
required in certain areas. Consult your national authority for possible
requirements. Changes or modifications not expressly approved by Shure
Incorporated could void your authority to operate the equipment. Licensing
of Shure wireless microphone equipment is the user's responsibility, and
licensability depends on the user's classification and application, and
on the selected frequency. Shure strongly urges the user to contact the
appropriate telecommunications authority concerning proper licensing, and
before choosing and ordering frequencies.
Information to the user
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: EMC conformance testing is based on the use of supplied and
recommended cable types. The use of other cable types may degrade
EMC performance.
Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate the
equipment.
Australia Warning for Wireless
This device operates under an ACMA class licence and must comply with
all the conditions of that licence including operating frequencies. Before
31 December 2014, this device will comply if it is operated in the 520-820
MHz frequency band. WARNING: After 31 December 2014, in order to
comply, this device must not be operated in the 694-820 MHz band.