Start-Up Troubleshooting - U-Line Wine Captain 2075DWRWC Installation Manual

To display actual temperature of each drawer, press the
" " and " " touch sensors simultaneously for three
seconds. The display indicates the actual temperature.
After approximately 10 seconds, the set point
temperature displays.
To adjust the temperature set point, touch and hold
either the " " or " " for that drawer for three
seconds. When the LED displays "SP," lift your finger from
the controller and the corresponding LED will begin to
flash the set point. Touch the "
desired set point displays. Wait 10 seconds for the new set
point to be saved. Wait 24 hours for the temperature to
stabilize before checking the actual temperature again.
Each wine compartment can be set to 40°F to 60°F.
Note: A flashing indicator light (LED dot) indicates a
thermistor error in that drawer. Call for service.
Other Settings
Other settings for the unit are factory preset. No adjustments
should be necessary at this time. See the User Manual for
information on:
• Adjusting the interior lighting
• Removing the lower drawer's wine caddy
• Using or disabling the cascade feature
www.U-LineService.com
2075DWRWC — Drawer Model Wine Captain
" or " " until the
®

Start-Up Troubleshooting

Q:
Problem
Unit does not appear to turn on when plugged in.
A:
Solution
Make sure outlet has power (circuit breaker has not
tripped).
IMPORTANT
See the User Manual's Troubleshooting Guide for more
solutions.
14
™
02/2005