Table of Contents
Advertisement
SYSTEM CONNECTIONS
Speakers
When connecting the speakers, make sure that (+) and (-) polarities
are matched properly. Otherwise, the sound may appear to be
lacking in the bass range and in stability.
Connect the speaker wire with the stripe to the red terminal (+) and
the other wire to the black terminal (-).
Note:
If desired, the speaker grilles can be removed.
WHAT TO DO IF....
R ch speaker
L ch speaker
AM loop aerial
If the operation of the system or display is not normal.
i
2.
Disconnect the mains lead.
Press the RESET button (bottom of the Tuner/Amplifier) for at
least 30 seconds.
Connect the mains lead.
Resume the operatrion.
External aerial
Aerial wire
EXT.ANT
4
Tuner/Amplifier
JCX-007 Set front bottom
* Use a plastic screw driver for adjustments.
* MODE : ST (Stereo)
¢ Speaker impedance : 6 ohm
¢« TUNING
FM : 87.5 - 108.0MHz (50kHz step)
AM : 522 - 1611KHz (9kHz step)
FM SGIN
|
L2151-a
Joii4
TP12(GND)
Ci
TP13(L)
"Ze 2103
<>< TP14(R)
J2104
TP15(GND)
SG RF Level : 75Q open Voltage dBuV
Antenna
> 75Q unbalanced , Modulation : 1 kHz
1.FM
Dev.
> £22.5kHz(MONO) +22.5kHz(STEREO) +6.75kHz(PILOT)
Adjusting
SG Modulation
> 1kHz, 30%
~
2.AM
Antenna, IRE Loop, Distance : 60 cm
Circuit
Advertisement
Table of Contents
