Zanussi DF67/42FF Instructions For The Use & Care page 13

During periods when the appliance is not in use,
take the following precautions:
* Unplug the appliance from the mains
supply.
* Remove all food from the appliance.
* Clean the interior and all accessories,
and leave the doors ajar after emptying,
cleaning and drying die compartments to
allow fresh air to circulate.
Replace The Interior Light Bulb
To replace the light bulb in the refrigerator
section, first disconnect the appliance from the
electricity supply. To release the plastic bulb
cover from its holder, simply press inward from
both sides and pull downwards and away from
the holder. Unscrew the bulb, and replace it with
a new one (maximum 15W) obtainable from
either your local Zanussi Service Force Centre or
High Street stores. Replace the cover and
reconnect the electricity supply (fig 3).
Door Reversal
1. If your fridge/freezer is already in use,
disconnect it from the electricity supply and
remove shelves and other loose items, including
food. Place the frozen food in boxes wrapped in
blankets or other suitable insulating material and
put in a cool place.
2.
Gently lay the appliance on its back with the
top held away from the floor by 5-8cm (2-3") of
packing.
3. Remove the freezer door first by removing the
three screws holding the bottom bracket in
position (fig 4).
4.
Lower the freezer door from its top pivot and
set aside.
5. Unscrew the freezer door top pivot from the
central bracket (fig 5) using the spanner provided.
Set the pivot aside. This pivot also holds the
fridge door so you should then be able to lower
the fridge door easily from its top pivot. Set the
door aside. Change the nut which rests on top of
the bracket to the corresponding hold on the other
side.
6. Unscrew the top pivot from its bracket (fig 6).
7. To refit the doors, screw the top pivot for the
fridge door into the bracket on the opposite side.
8. Locate the fridge door onto this pivot and
screw the bottom pivot through the hole in the
central bracket to secure the fridge door.
9. Change the position of the pivot in the bottom
bracket for the freezer door to the opposite hole in
the bracket.
10.
Locate the freezer door onto the top pivot and,
holding it in position, push the bottom pivot into
the locating hole and screw the attached bracket
into the matching holes in the cabinet with the
three screws removed from the other side.
11.
Remove the two door handles by unscrewing
them and refit on the opposite side.
13