Download Print this page

Pioneer MS-Z63 Operating Instructions Manual page 14

Music system /optional stereo turntable

Advertisement

TROUBLESHOOTING
to carry out repair work.
Amplifier section
Symptom
Probabie Cause
Remedy
No sound from speakers.
Cassette tape deck section
* Is volume level turned down ?
* Are head phones connected to the PHONES jack?
* Increase volume level.
* Disconnect the headphones.
Tape deck will not work.
* Is deck in pause mode?
* Is tape loaded correctly?
* Press PAUSE (Il) button to release pause mode.
* Load correctly.
No sound from tape deck.
* Is FUNCTION switches selected to TAPE?
«Is a blank tape loaded?
* Are heads clean?
© Set switches to TAPE.
* Load a pre-recorded tape.
* Clean heads.
|
Recording not possible.
¢ Is tape loaded in DECK
I?
* Are heads clean?
* (s a tab on the cassette tape removed?
* Load tape in DECK ! for recording.
* Clean heads.
* Use a cassette tape with tabs, or place a piece of
adhesive tape on the back edge (see page 12).
Copying not possible.
* Is a tab on the cassette tape removed?
¢ Use a cassette tape with tabs, or place a piece of
adhesive tape on the back edge (see page 12).
| Noise picked up during recording
[ of tape, record, radio, etc.
* Is power to TV set turned on ?
* Is unit located too close to TV set?
* Turn off TV set.
* Move unit at least from TV set.
Tuner section
No sound,
* \s the band selector switch selected to AM or
FM?
* Set switch to AM or FM
AM reception not possible.
* Is station tuned in properly?
* Tune in station properly.
FM reception not possible.
* ls antenna connected?
¢ Connect antenna, follawing instructions on
page 13.
Large amount of noise.
T
* Are radio waves weak, causing antenna input to
be insufficient?
* Has the cannecting cord of the CD player been
placed too close to the antenna cable?
* Use external antenna.
* Place the cord of the CD player farther away
from the antenna cable or turn off the CD player.
Turntable
No sound,
«Is FUNCTION switches selected to PHONO?
* Set switches to PHONO.
Static, scratching noise
* Is record surface dirty?
* Clean record.
produced.
* Is record warped or scratched?
* Replace record.
* {ts stylus clean?
¢ Clean stylus.
* ts stylus worn out?
° Replace stylus.
14
<AZ01036 >>

Advertisement

loading

This manual is also suitable for:

Pl-z93