Igloo IH 45 Short Operating Manual page 10

• The refrigerant in the refrigerant circuit is
highly flammable and in the event of a leak-
age combustible gases could build up if the
appliance is in a small room.
In the event of any damage to the refrigerant
circuit:
– Keep naked flames and potential ignition
sources away from the refrigerator.
– Ventilate the room well.
– Switch off the refrigerator.
For cooling devices with R600a refrigerant:
• The refrigeration circuit contains a small
quantity of an environmentally friendly but
flammable refrigerant. It does not damage
the ozone layer and does not increase the
greenhouse effect. Any leaking refrigerant
may ignite.
• Keep the ventilation openings on the device
housing or in installations free of obstruc-
tions.
• Do not use any mechanical objects or other
means to speed up the defrosting process,
unless they have been recommended by the
manufacturer for this purpose.
• Do not open or damage the refrigerant
circuit.
• Do not use electrical devices inside the cool-
ing device unless they are recommended by
the manufacturer for that purpose.
Health hazard
• Children must be supervised to ensure that
they do not play with the device.
• Cleaning and user maintenance must not be
carried out by unsupervised children.
Explosion hazard
• Do not store any explosive substances such
as spray cans with a flammable propellant in
the cooling device.
!
CAUTION! Failure to obey these cau-
tions could result in minor or moder-
ate injury.
Electrocution hazard
• Before starting the cooling device, ensure
that the power supply line and the plug are
dry.
• Disconnect the cooling device from the
power supply
– Before each cleaning and maintenance
– After every use
10
Health hazard
To avoid contamination of food, observe the
following instructions:
• Check if the cooling capacity of the device is
suitable for storing the food to be cooled.
• Food may only be stored in its original pack-
aging or in suitable containers.
• Opening the cooling device for long periods
of time can cause significant increase of the
temperature in the compartments of the
device.
• Clean regularly surfaces that can come in
contact with food and accessible drainage
systems.
• If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the lid open to prevent mold devel-
oping within the device.
A
NOTICE! Damage hazard
• Check that the voltage specification on the
data plate corresponds to that of the energy
supply.
• Only connect the cooling device as follows:
– With the DC connection cable to a DC
power supply in the vehicle
– Or with the AC connection cable to an AC
power supply
• Never pull the plug out of the socket by the
cable.
• If the cooling device is connected to a DC
outlet, disconnect the cooling device and
other power consuming devices from the
battery before connecting a quick charging
device.
• If the cooling device is connected to a DC
outlet, disconnect the cooling device or
switch it off when turning off the engine.
Otherwise the battery may be discharged.
• The cooling device is not suitable for trans-
porting caustic materials or materials con-
taining solvents.
• The insulation of the cooling device contains
flammable cyclopentane and requires
special disposal procedures. Deliver the
cooling device at the end of its life-cycle to
an appropriate recycling center.
4445103962
EN