Panasonic TX-86PW100A Operating Instructions Manual page 43

To keep your Panasonic Television in good working order pleasf^erve the following warnings and-
Danger
Do not insert foreign objects.
(Keep metal or easily inflammable
objects out of this television).
Danger
Always pull the plug out of the
wall outlet by holding the plug
itself.
Do not
pull the plug by the power
cord.
Danger: High Voltage
Do not remove the rear cover, as
High Voltage components will be
exposed.
Danger
Do not alter the power cord.
Do not use if the power cord or
plug is damaged or if the plug
does not fit tightly Into the socket.
DO NOT touch the aerial cable
and metal parts of the television
when there is lightning around.
During storms switch the television
off. DO NOT leave in standby.
Remove the plug from the wall
socket.
Do not place any containers of
water or other liquids on or near
this television.
Do not place the TV in humid or
dusty locations, or areas exposed
to smoke or steam.
Avoid exposing the television to
direct sunlight or any other sources
of direct heat.
Do not allow the power cord to
come Into contact with flame or
hot surfaces.
Do not place heavy objects on
the power cord.
Adequate ventilation is essential.
Allow a gap of at least 10cm
around the TV, even in a cabinet
or between shelves.
Do not stand or place heavy
objects on top of the television.
Do not subject the TV to any
physical shocks. Always remove
any connector cables when
moving the TV. When moving the
TV from one place to another
wrap it in something protective.
Remove the Power Plug from the
wall socket when the Television is
not going to be used for an
extended period of time.
Turn the power OFF before
connecting other electrical
equipment.
Safety
First
In the advent of unusual opera^n
(e.g. odd sounds, smoke or
aromas), turn the television Off
and remove the power cord from
the wall socket. Then call the
Television Service Centre: this
may reduce the possibility of
expensive repair costs.
Any external aerial should be
installed by a reputable qualified
installer and should comply with
Australian Standard AS1417.1.
43