AEG LTN6K6210B User Manual page 22

If the ProSense phase is already carried
out and the water filling is already
started, the new programme starts
without repeating the ProSense phase.
The water and the detergent are not
drained out in order to avoid waste.
11.11 The ProSense System load
detection
After touching the Inicio/Pausa
1. The ProSense System starts the laundry
load detection to calculate the real
programme duration. The indicator
and the time dots flash.
2. After about 15 minutes the display shows
the new programme duration: the
indicator goes off and the time dots
stops flashing.
The appliance adjusts automatically the
programme duration to the load to
achieve perfect washing results in the
minimum possible time. The programme
duration could increase or decrease.
The ProSense System detection is
carried out with complete washing
programmes only (no skipping phase
selected).
The ProSense System is not available
with all programmes such as :Lana/Lãs
+Seda, Aclarado/Enxag.,
Centrif.Descarga, and programmes with
short cycles.
11.12 Opening the Lid when the
programme operates
CAUTION!
If the temperature and level of the water
in the drum are too high, the
indicator stays on and you cannot open
the lid.
To open the lid proceed as follows:
22 ENGLISH
1. Press the button On/Off for some
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.13 Opening the Lid when the
delay start is active
While the delay start operates, the appliance
lid is locked.
button:
To open the appliance lid:
1. Press button Inicio/Pausa.
The
2. Open the appliance lid.
3. Close the lid and press button Inicio/
Pausa.
The delay start continues.
11.14 End of cycle
When the programme has finished, the
appliance stops automatically. The acoustic
signal operates (if it is active).
In the display
indicator
The indicator of Inicio/Pausa button goes off.
1. Press button On/Off to deactivate the
appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the appliance again,
the display show the end of the last set
programme. Turn the programme knob to
set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew and
odours
11.15 Draining water out after end
of cycle
The washing programme is completed,
but there is water in the drum:
indicator goes off.
comes on and the lid locked
goes off.