Sony FD Trinitron KV-14LT1B Service Manual page 12

SECTION 2 DISASSEMBLY
2-1. Rear Cover. Removal 2-2. A Board PWB Removal [ Step 1]
=~
~ Remove screw.
Release the mains power cable from its securing posts.
Remove the rear cover fixing screws indicated. Pull the rear
cover away from the front beznet until clear of chassis.
Note : Use a cross-head screwdriver with a blade length of at
least 200mm.
RemoveFBT >
2-3, A. Board PWB Removal [ Step 2 ] slipper bracket. 7
2-5. Wire:Dressing
Lis
Release the 2 securing
clips located at either
side of the chassis and
slide the PWB clear of
the bracket.
2-4. Service Position
Place the A Board PWB in the
position indicated to carry out
servicing.
Ensure that all wires do not touch heat-sinks and high
temperature hot spots. All wires must be kept at a minimum
distance of 20mm away from the EHT lead.
12