Before First Use - AEG LTR6G271C User Manual

simultaneously until the
on/goes off above the
9.4 Permanent Extra Rinse
With this option you can permanently have an
extra rinse when you set a new programme.
• To activate/deactivate this option touch
the Skvrny/Předpírka button and the
Máchání . The corresponding indicator
next the touch button illuminates.
9.5 Operating Hours Counter
It is possible to visualise the total operating
time of the appliance in hours, starting from
the first switching on. This value will count
operating time of the cycles (does not include
pauses, delayed start time). To visualise this
value, proceed as follows:
1. Switch the appliance on by pressing Zap./
Vyp. button.
2. Turn the programme knob to the Eco
40-60 programme (1st position
clockwise).
3. Press and hold the Antialergický and
Skvrny/Předpírka buttons for some
seconds (within 10 seconds after the
switching on. After these 10 seconds, the
key combination activates and
deactivates the acoustic signals).
4. After 3 seconds the total hours operated
by the appliance are shown in the display:
e.g. 1276 hours, the display shows the
text Hr for 2 seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens and
units).

10. BEFORE FIRST USE

During installation or before first use you
may observe some water in the
appliance. This is residual water left in
the appliance after a full functional test in
the factory to ensure the appliance is
delivered to customers in perfect working
order and is no cause for concern.
1. Connect the mains plug to the mains
socket.
20 ENGLISH
indicator comes
indicator.
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
9.6 Factory Reset
This function allows to restore the factory
default options. To activate this option follow
steps below:
1. Switch the appliance on by pressing Zap./
Vyp. button.
2. Turn the programme knob to the
Syntetika programme (3rd position
clockwise).
3. Press and hold the Antialergický and
Skvrny/Předpírka buttons for some
seconds (within 10 seconds after the
switching on. After these 10 seconds, the
key combination activates and
deactivates the acoustic signals).
4. The display will show
seconds.
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
2. Open the water tap.
3. Put 2 litre of water in the detergent
compartment for washing phase.
This activates the drain system.
4. Put a small quantity of detergent in the
compartment for washing phase.
5. Set and start a programme for cotton at
the highest temperature without laundry.
This removes all possible dirt from the drum
and the tub.
for about 5