Friedrich Wallmaster WCT16 Installation And Operation Manual page 14

J. STARTUP AND OPERATION
J.3 Control Panel Operation
All of the control panel function buttons and mode icons can be viewed in Figure J.3.2
Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The backlight on the power switch will
automatically turn off after 20 seconds of inactivity.
Display – The display is a high efficiency LCD with a built-in backlight. After 20 seconds of inactivity, the display switches off. Touching any button automatically changes
the display to full brightness.
There are three control push buttons on each side of the display.
SYSTEM FAN MODE
Cycles between Sets fan to either:
AUTO, HEAT, - Cycle automatically
COOL, or FAN - Run continuously
ONLY
(if equipped)
Figure J.3.1
COOL HEAT FAN ONLY
Figure J.3.2
MODE
Cycles between
COOL, HEAT, FAN
ONLY or -AUTO-
(if equipped)
FAN
Sets fan to either:
- Automatically cycle
- Continuously run
FAN SPEED
Sets fan speed:
LOW, MED, HIGH,
OR MAX
(Actual settings are
model dependant)
14
FAN SPEED TEMPERATURE
Sets fan speed: Increment UP
LOW, MED,
HIGH or AUTO
TEMPERATURE
(if equipped)
Increment DOWN
-AUTO- ON / OFF
Automatically switches Turns unit on/off
between cool & heat
TIMER IR WINDOW
Turns ON or OFF Do not block
DISCONNECTED CONTROL
FROM POWER BOARD LOCKED
2 DIGIT DISPLAY
Shows Setting for:
- Set Point (Temperature)
- Clock (AM/PM)
ON / OFF
Turns unit on/ off
WI-FI OPERATING
STATE
IR
RECEIVER
TEMPERATURE
UP
TEMPERATURE
DOWN
TIMER
shows on or off
FILTER
Check / clean