Before Requesting Service - Panasonic NN-C980B Operating Instructions Manual

Before Requesting Service
F- ALL THESE THINGS ARE NORMAL:
The oven causes interference Some radio and TV interference might occur when you cook with the
with my TV. microwave oven. This interference is similar to the interference caused
by small appliances such as mixers, vacuums, hair dryer, etc. It does
not indicate a problem with your oven.
The oven lights dim. When cooking with a power other than P10 - P3, the oven must cycle
to obtain the lower power levels. The oven light wilt dim and clicking
noises can be heard when the oven cycles.
Steam accumulates on the During cooking, steam and warm air are given off from the food. Most
oven door and warm air comes of the steam and warm air are removed from the oven by the air which
from the oven vents, circulates in the oven cavity. However, some steam will condense on
cooler surfaces such as the oven door. This is normal.
I accidentally ran my Running the oven empty for a short time will not damage the oven.
microwave oven without any However, we do not recommend this to be done.
food in it.
There are humming and These noises occur as the oven automatically switches from microwave
clicking noises from my oven power to Convection, to create the Combination setting. This is
when I cook by Combination. normal.
The oven has an odor and It is essential that your oven is wiped out regularly particularly after
generates smoke when using cooking. Any fat and grease that builds up on the roof and walls of the
the Bake, Combination and oven will begin to smoke if not cleaned.
_Broil function.
PROBLEM
Oven will not turn on.
Oven will not start cooking.
POSSIBLE CAUSE
_-e-_en is not plugged in
securely.
Circuit breaker or fuse is tripped Reset circuit breaker or replace
or blown, fuse.
There is a problem with the Plug another appliance into the
outlet, outlet to check if the outlet is
working.
• The door is not closed Close the oven door securely.
completely.
Start pad was not pressed after Press Start pad.
programming.
Another program has already Press Stop/Reset pad to cancel
been entered into the oven. the previous program and
program again.
The program has not been Program again according to the
entered correctly. Operating Instructions.
Stop/Reset pad has been Program oven again.
pressed accidentally.
J
j L REMEDY
Remove plug from outlet, wait 10
seconds and re-insert.
The words "DEMO MODE"
appear on the screen.
When the oven is turning on,
there is noise coming from
Ceramic Tray.
I Oven is set at Demo Mode.*
See page10 (To use Function)
to turn off Demo Mode.
I Roller Ring and oven bottom are Clean these parts according to
dirty. Care of Your Oven (see next
page).
* DEMO MODE is designed for retail store display.
Cooking and other functions will not operate during Demo Mode.
If it seems there is a problem with the oven, contact an authorized Service Centre.
23