Table of Contents
Advertisement
3N FOR USE
ffNOTE
]
[,Cables
used here are commercially
available.
[,For
your safety and to avoid damages
to the unit, unplug
the antenna
cable from the ANT. jack
Lbefore
moving
the unit.
- ANTENNA/CABLE
CONNECTION
[R_'ar of this u_lkl
IF YOU HAVE
A JACK
ON THE
WALL
Connect
the TV to the wall-mounted
antenna jack
with on RF cable (commercially
available).
IF YOU HAVE
A WIRED
CABLE
Connect
the TV to the wired anteuna cable.
NOTE
• Before plugging the autenua into the ANT. jack of the
unit, check that the pin is not bent. If it is bent,
straighten the pin as illustrated, then plug the pin into
the ANT. jack of the unit.
Bent pin
Plug
(Needs to be
(Straight
pin)
straightened)
- CABLE/SATELLITE
BOX CONNECTION
[Rear of this tmitl
Cable Box
or Satellite
Box
WHEN
USING
CABLE
BOX/SATELLITE
BOX
If your cable service supplies
you with a converter
box or if you use a satellite
system, you can use the
basic connection
shown above.
Channel
selection
must be made with the converter
box or satellite box. This metros that channels
ctmnot
be chtmged
using the remote
control of this unit.
75-ohm
Coaxial
Cable
from Cable Company
or Satellite
Antenna
NOTE
For CAT¥ system installer:
• This reminder is provkted to call the CATV system installer's attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding
system of the building as close to the point of cable entry as practical.
10
EN
Advertisement
Table of Contents
