Advertisement
HOW TO MOVE THE CHASSIS INTO SERVICE POSITION
1.
Remove the bead clamper from the mains lead and affix,using back cover screw, into top right-hand cabinet rib (A),
shown in
Fig.4.
2.
Hold and lift the rear of the E-PCB chassis and gently pull the chassis toward you, as shown in
3.
Release the respective wiring clips and rotate the chassis vertically through 90°, anti-clockwise.
4.
Locate the base of the chassis frame into the hole (B), shown in
5.
Clip the chassis frame onto the bead clamper, shown in
6.
After servicing replace the bead clamper and ensure all wiring is returned to its original position before returning the
receiver to the customer.
Fig.5.
Fig.6.
Fig.5.
(A)
Fig.4.
Fig.6.
4
Fig.4.
(B)
Advertisement
