Sony CMA-10 Service Manual page 7

Rear panel
REMOTE
REMOTE connector
== DC OUT
VIDEO IN
(4)REMOTE connector (BNC type)
Connect to the REMOTE connector of the camera to
remotely control the white balance and the pedestal
level adjustments.
Notes
eWhen this connector is connected to the camera,
the camera can be remotely controlled by the
adaptor. Also, the adaptor's operation takes priority
over the camera's operation.
elf you wish to cancel the white balance control by
this unit and to adjust the white balance by the
camera, first turn off this unit, then disconnect the
cable connecting the REMOTE connectors.
lf the cable is disconnected with this unit powered,
the camera's white balance adjustment function
will be inoperative. In this case, turn off the POWER
switch, and after a few seconds, turn it on again, so
that the adjustment function will be operative.
(2]pc OUT (DC power output)/VIDEO IN (input) connec-
tor (BNC type)
DC power is supplied from this connector to the
camera, and a video signal from the camera is input
to this connector. Refer to '"'Connection Examples"
on page 1-4.
[3]VIDEO OUT (output) connector (BNC type)
A video signal is output from this connector. Refer to
"Connection Examples" on page 1-4.
CMA-10/10CE (U,CA,EK)
Oi eee
WARNING FOR THE CUSTOMERS IN THE UNITED
| CMA-10/10CE
| 4 |AC IN receptacle
(4) AC IN (AC input) receptacle
Connect to an AC outlet with the supplied AC power
cord.
KINGDOM
THIS APPARATUS MUST BE EARTHED
IMPORTANT
The wires in this mains lead are coloured inaccord-
ance with the following code:
Green-and-yellow: Earth
Biue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug pro-
ceed as follows:
The wire which is coloured green-and-yellow must be
connected to the terminal in the plug whichis mark-
ed by the letter E or by the safety earth symto! + or
coloured green or green-and-yellow. The wil which
is coloured blue must be connected to the lerminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be camected
to the terminal which is marked with the leter L or
coloured red.
1-3