Hill Descent Control - Chevrolet COLORADO ZR2 2024 Getting To Know Manual

HILL DESCENT CONTROL

Hill Descent Control sets and maintains vehicle speed when descending a very steep hill.
It can maintain vehicle speeds from 1–19 mph on an incline greater than or equal to a 10%
grade (or an incline of 6 degrees).
To turn the system on or off, go to
Controls > Drive & Park > Hill Descent
Control on the infotainment screen.
Vehicle speed must be below 37 mph
to enable the system. The
will illuminate on the Driver
Information Center.
Increase or decrease speed by
applying the accelerator or pressing
the Cruise Control +/– buttons. The
adjusted speed becomes the new set
speed.
The symbol flashes when the system is actively applying the brakes to maintain
vehicle speed.
Hill Descent Control will remain enabled between 19 and 37 mph, but vehicle speed
cannot be set or maintained in this range. It will automatically disable if the vehicle speed
is above 50 mph or above 37 mph for 30 seconds.
TRACTION CONTROL AND STABILITRAK SYSTEMS
The Traction Control system lim-
its wheelspin and the StabiliTrak
Electronic Stability Control (ESC) sys-
tem assists with directional control of
the vehicle in difficult driving condi-
tions. Both systems turn on automati-
cally when the vehicle is started. The
Traction Control and StabiliTrak cali-
brations are altered while in Off-Road,
Terrain or Baja mode.
To turn Traction Control or
StabiliTrak on or off, go to Controls >
Drive & Park > Traction Control on the infotainment screen.
Note: StabiliTrak will turn on automatically if the vehicle exceeds 35 mph unless Off-Road, Terrain or
Baja mode is enabled and active.
6
symbol
See Driving and Operating in your Owner's Manual.
See Driving and Operating in your Owner's Manual.
Some equipment shown may not be included in your vehicle.