Speaker Systems - Denon DRA-565RD Operating Instructions Manual

Preset (Preset station buttons)
These buttons are used for storing stations or recalling
stations which have been preset. Using the SHIFT button
you can preset a total of 40 FM or AM stations into preset
channels.
Once a radio has been memorized, the same station can
later be tuned in instantly simply by recalling the corres-
ponding preset channel with PRESET UP or DOWN button.
DISPLAY
© €@e8 8® 88 6
RDS indicator
This lights when receiving RDS broadcasts, and flashes
during the RDS search operations.
TA indicator
This lights when receiving traffic announcements.
TP indicator
This flashes during the TP search operation and lights
when TP stations are tuned in.
PTY indicator
This flashes during the PTY (Programme type) search
operation.
TUNED indicator
This lights when a station is property tuned in.
STEREO indicator
This lights when receiving stereo broadcasts. It remains off
when receiving AM broadcasts.
AUTO indicator
This indicates the tuning mode. It lights in the auto mode,
and remains off in the manual mode.
NOTE:
e TP (Traffic Programme)
Stations scheduled to broadcast traffic programmes
e TA (Traffic Announcement)
Traffic information broadcasts
REAR PANEL
(2)
FM ANT (FM antenna terminals)
75-ohm coaxial cable can be connected to this terminal. For
antenna connecting procedure, see the ANTENNA IN-
STALLATION.
GND (Grounding terminal)
The grounding wire of the turntable is connected here.
e¢ Hum or noise may be generated if the grounding wire is
not connected.
AM ANT (AM antenna terminals)
Connect the attached AM loop antenna. (Refer to page 10
for connections).
Connect to this terminal when a medium wave outdoor
antenna is used.
PHONO (Phono input terminals)
The output cord of the turntable is connected here.
Since the input sensitivity of "PHONO" is extremely high,
do not use the unit without the input pin cord. If used
without this cord, the speakers may generate hum.
cD
The output cord of the CD player is connected here.
VIDEO
A VIDEO, such as a VCR or Video Disc may be connected
here.
e TAPE-1, TAPE-2 (Tape deck playback/recording
terminal) (DRA-565RD)
Two tape decks or tape deck can be connected to these
jacks for full-fledged playback, recording and tape
dubbing operation.
e TAPE (DRA-365RD)
Tape decks can be connected for full use including
playing or copying.
®
e e 6 9
ENGLISH
e SHIFT/PTY button
MEMO indicator
CH indicator ;
This lights when the preset channel number and shift mode
(A, B, C, D or E) are displayed.
© TAPE-1/TAPE-2 indicator (DRA-565RD)
The TAPE-1 indicator lights when the TAPE-1 source is
selected with the tape selector buttons. The TAPE-2
indicator
lights when
the TAPE-2
source is selected.
e TAPE indicator (DRA-365RD)
The TAPE
indicator lights when
the TAPE
source is
selected with the tape selector buttons.
Multi function display
This displays
the frequency,
station
name, programme
type, etc.
PRE-OUT (DRA-565RD only)
The rated output is 2 volts.
SPEAKER SYSTEMS (Speaker terminals)
Two pairs of speakers A and B can be connected to these
terminals.
AC OUTLET (AC power outlets)
AC CORD (Power cord)
Connect this cord into the wall outlet.