Advertisement
Servicing
Door reversal
& panelling
directions2)
Should service be required for this
appliance, contact your local Zanussi
Service Agent, whose details can be
found under «Z» in your local telephone
directory. Before requesting service the
following simple checks may save you
inconvenience and expense:
If there are water drops on the bottom
of the fridge compartment, check that
the cTefrost water drain opening is not
obstructed.
Check that the plug is firmly in the wall
socket;
Check that there is an electricity supply
to the socket by plugging in another
appliance;
Turn the thermostat knob to the coldest
setting;
If the motor still does not run, contact
your Service Agent.
Please note that it will be necessary
to provide proof of purchase for any
in-guarantee service calls.
Replacing the interior light bulb
If the interior light does not come
on when the door is opened, you will
need to gain access to the interior light
bulb. To do this, remove the bulb
housing cover by unscrewing the screw
and by sliding it out.
Check that the bulb is correctly screwed
into its socket. If it is burnt out,
replace with a similar 10W bulb.
Replace the plastic cover by sliding it
back in. Fasten it by means of the
previously removed screw.
Door reversal directions
Before carrying out the operations
described below, pull out the mains plug
from the wall socket
Proceed as follows:
a) Remove bottom hinge 6;
b)
Remove door 5;
c) Remove pivot 3 from the top hinge 2
and refit it in the corresponding hole on
the opposite side;
d)
Refit the door and the bottom hinge;
e) Remove handle 4 and refit it on the
opposite side.
Panelling* the door
a) Take off the removable side of the door
frame;
b)
Loosen, without removing them, all
remaining screws securing the door
frame;
6
Advertisement
