Honda Z50A Manual page 34

32
CD
6 rnrn Jock nut 11) C1rculJr lock nut
@
BrJke cable adjusting bolt
@
Brake rod @
Fig. 56
CD
Pin
11)
Brake pedal pin nut
@ Brake pedal spring @ Stop lamp switch spring
Fig. 57
Fig. 58
-
2. Loosen the circular lock nut and remove •
the brake cable from the brake rod
@
(Fig.
56).
3. Remove 6 mm lock nut and a pin. •
Then remove the brake rod
@
and
@
(Fig.
56, 5 7).
4. Remove the brake pedal pin nut. unhook
the brake pedal spring and stop lamp
switch spring from the brake pedal and
remove the brake pedal (Fig.
57).
5. Perform the rear wheel removal
C. Inspection
1 . Check the brake rods for bent and
damage. Straighten the bent rod and
replace the rod if damaged.
2. Check the spring and brake pedal for
deformation or damage. If damaged,
replace them with new one.
3. Check the brake cable for break. Replace
the broken cable with new one.
D.
Reassembly
Perform the reassembly in the reverse order
of disassembly.
E. Adjustment
1 . Make the adjustment of left hand lever
play independently by turning the brake
cable adjusting bolt. Turn clockwise to
increase the play. The nominal free play
is 0.8-1.2 (20-30mm).
•
-
-
-
-
-
-
-
-
-
-
-
-
-
-