Honda Z50A Manual page 24

22
CV Micrometer
@
Gear shift fork ends
Fig.
46
C. Inspection
1. Measuring thickness of the gear shift
fork ends
The thickness of the shift fork end is
measured with a micrometer (Fig. 46).
Standard Value
0.191-0195
(4.86-4.94 mm)
Serviceable Limit
Replace if under
0.181 (4 6 mm)
2. Measuring the inside diameter of the
gear shift fork
The inside diameter of the gear shift fork
is measured with a cylinder gauge or an
inside micrometer (Fig. 47).
Standard Value
1.3385-1.3395
(34.0-34 025 mm)
Serviceable Limit
Replace if over
1.346 (34.2 mm)
-
-
•
•
-
•
-
•
CD Gear shift fork
@
Cylinder gauge •
Fig. 47
CD Gear shift drum
@
Micrometer
Fig. 48
CD Guide pin clip
Fig. 49
3. Measuring the outside diameter of the
gear shift drum •
The diameter is measured with a micro-
meter (Fig. 48).
Standard Value
1.3366-1.3377
(33.95-33 98 mm)
D. Reassembly
Serviceable Limit
Replace if under
1.335 (33.9 mm)
Perform the reassembly in the reverse
order of disassembly. Exercise care on the
following points.
Make sure that the guide pin and guide pin
clip are properly installed on the gear shift
drum for both the right and left shift forks
(Fig. 49).
•
-
-
•
-
-
-
-