True TDBD-72-4 Installation Manual page 12

TEMPERATURE CONTROL ADJUSTMENT FOR
HIGH ALTITUDE ONLY!
TERMS:
Cut-out - Temperature sensed by the
controller that shuts the compressor
off.
Cut-in - Temperature sensed by the
controller that turns the compressor
on.
REQUIRED TOOLS
• Phillips Head Screwdriver
• 5/64" or 2 mm Allen Wrench
• T-7 Torx Wrench
___________ STEP 1 ___________
Unplug the cooler.
___________ STEP 2 ___________
Remove the screws that secure the
temperature control to the inset box
lower left side of the cabinet (when
facing the front of the cabinet).
___________ STEP 3 ___________
Pull out gently from cabinet.
NOTE:
Mechanical temperature
controllers are affected when
functioning at high altitude.
The cut-in and cut-out
temperatures will be colder than
when the controller functions
closer to sea level
10
10
MAINTENANCE, CARE & CLEANING
MAINTENANCE, CARE & CLEANING
___________ STEP 4 ___________
For high elevation installations, it may
be necessary to "warm-up" the set
points. To make the adjustment,
insert the appropriate tool in each
adjustment screw and turn
1/4 of a revolution clockwise (to the
right). This procedure will adjust
both the cut-in and cut-out about 2°F
warmer.
___________ STEP 5 ___________
Make sure to reconnect the pink wire
to the proper spade terminal when
reinstalling.
Danfoss Temperature Control (High Altitude Adjustment Only!)
............ www.truemfg.com ............
............ www.truemfg.com ............
True Food Service Equipment, Inc.
True Food Service Equipment, Inc.
The temperature control is located
inside the rear of the unit at the top
and to the left just inside the rear
sliding doors.
Cut-out Adjustment Screw Allen (5/64"
or 2 mm) (clockwise for warmer)
Cut-in Adjustment Screw Torx (T-7)
(clockwise for warmer)
Compressor Connection(pink)
Compressor Connection
(pink)
10
10