Advertisement
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you should clean your
kettle before use by boiling the Max capacity of water once and then discarding the water
twice. Wipe the surface with a damp cloth.
NOTE: The max capacity of kettle is 1.7L.
USING YOUR ELECTRIC KETTLE
1. Place the kettle on the flat surface.
2. To fill the kettle, remove it from the power base and open the lid by pressing down lid
release button, then fill the kettle with the desired amount of water and close the lid. The
water level must be within the Min and the Max level. Too little water will cause the kettle
switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout
when boiling. Ensure that the lid is firmly in place before plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the switch and the indicator will light
up, and then the kettle starts to boil the water. The kettle will switch off automatically once
the water has boiled. If necessary, it will take you 30 seconds to wait before pressing the
switch again to re-boil the water. You may shut off the power by lifting switch up or directly
lift the kettle from the power base at any moment to stop boiling process.
NOTE: Ensure that switch is free of obstructions and the lid is firmly closed, the kettle will
not turn off if the switch if be constrained or if the lid is opening.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may
result in scald, besides, don't open the lid while the water in the kettle is hot.
6. The kettle will not re-boil until the switch is pressed again. The kettle may be stored on
the power base when not in use.
NOTE: Always disconnect the power supply when not use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the function of boil-dry
protection will automatically switch off the power. If this occurs, allow the kettle to cool
prior to filling with cold water before re-boiling.
4
Advertisement
