Using The Tape Counter; Insert A Scene In The Middle Of A Recorded Tape - Sony CCD-FX520 Operation Manual

Using the Tape Counter Inserting a Scene in the Middle of a Recorded Tape
~
During recording or playback, the digrts on the tape counter indicate the elapsed recording or playback time. You Can insert a scene in the middle of a recorded taps by setting the starting point and anding point.
4 previously recorded partion will be erased.
Referring to the Amount of Elapsed Time and a Particular Point
Press COUNTER RESET at the beginning of the tape. The counter in the viewfinder displays *0:00:00". The
counter shows the elapsed time so that you can refer to the amount of elapsed time. You can also use the
counter as an index to find a particular point.
Returning to a Pre-registered Position
You can easily go back to the desired point on a tape after playback.
(1} During playback. press COUNTER RESET at the point you later want to locate. The counter shaws
"0:00:00" in the viewfinder. (2) Press -~ when you want to stop playback. (3} Press ZERO MEM to stop
rewinding at the counter's zero point. The "ZERO MEM" indicator flashes in the wiewtinder. (4) Press <<.
The tape stops automatically when the counter reaches approximately zero
(1} While looking in the viewfinder in the Standby mode, keep pressing the + ar — side of EDITSEARCH and
release the button where you want to end the insertion [b]. {2} Press COUNTER RESET to set the counter to
zero. (3) While ooking in the viewtinder. keep pressing the — side of EDiTSEARCH and release the button
where you want to start the insertion [a]. (4) Prass ZERO MEM to stop recording of insert at the counter's zero
point. (5) Press START/STOP. Insert recording begins. Fhe insert recording stops automatically at the counter
zero point.
SUE] PapsO3ey & 4O SIPPY Sy) UI BUBDS Y HUNseSU ade) sy) GUIS
+ enTseancn -—G)
+ EDITSEA
* Samething must be recorded on the tape in order for the tape counter io function. Tape counter does not _ : i a > yf 0012S
work on a blank tape. not Ssibdd
|
« There may be a discrepancy ot several seconds from the actual time.
Notes on ZEAO MEM
« When you press ZERO MEM. the counter's zero paint is memonzed.
* This function is cancelied automatically once the tape is rewound or sent forward to the point you
pre-registered.
« Be sure to press ZERO MEM atter stopping the tape. |t does not function during recording or playing back.
Using this function in reverse.
You can return to a desired position after rewinding with this function. Press COUNTER RESET at the pont
you want to return to later. Press <@. Press — when you want to stop rewinding. Prass ZERO MEM.
Press i. The tape automatically stops near the zero point you first set.
Canceling the ZERO MEM
Press ZERO MEM. The ZERO MEM indicator disappears.
Note on the recorded picture :
The picture may be distorted at the ending point when played back. 33