Sony Trinitron KV-13TR28 Operating Instructions Manual page 11

Chapter 1: Setting Up
Connecting TV Antenna/Cable
Although you can use either an indoor or outdoor antenna with the TV, an outdoor antenna will provide you with better picture
quality. You can receive cable TV by connecting a cable supplied by your local cable company.
Oforalel=xei diate Msn ariel al ame) MA dnlarl Ola | ait Oxelanle)iar-\élelam-Valt-)alat- Meme) a O7-@ BM @r-] 0) (2
75-ohm coaxial cable (round)
Check your antenna cable type and prepare the end
of the cable using the F-type connector.
Attach an F-type connector (not supplied).
jm
a _=—
7 mm (1/4 inch) 10 mm (3/8 inch) F-type connector
—o)
3 mm (128 inch)
C RPE
qd —)»
Plug the connector into the VHF/UHF terminal at the
rear of the TV.
{Rear of TV)
ae
VHF/UHF
* Most combination antennas are equipped with a signal
splitter.
Remove the splitter and attach the appropriate connector.
(for KV-20TS50)
Do not connect the antenna cable to the [R EMITTER terminal.
If you do so, the TV antenna could break.
The IR EMITTER terminal is covered with a plastic cap to
prevent misconnection.
300-ohm twin-lead cable (flat)
Check your antenna cable type and prepare the end of
the cable using the 300-ohm twin-lead cable.
Attach the supplied antenna connector.
Loosen both
screws on the
connector with a
screwdriver.
Attach the cable
and tighten both
screws with a
screwdriver.
Plug the connector into the VHF/UHF terminal at the
rear of the TV.
(Rear of TV)
VHF/UHF
Chapter 1: Setting Up 1 1
sjosju0g aty 6uy2907
aygeg/euuaquy Al Gunseuu0g g