Magnavox 27MT5005D User Manual page 21

utoLock allows the viewer to block out any channels. A channel blocked by the AutoLock control cannot be viewed
until a correct access code is used to unlock the channel for viewing.
Follow these steps for Digital Mode Digital Mode Analog Mode Follow these steps for Analog mode
Press MENU button on
the remote control to
display the onscreen menu.
Press CURSOR A or
V to scroll through the
onscreen menu until
you see DTV Setup
highlighted. Press
CURSOR > to display
DTV
Setup features.
Press CURSOR A or
V to scroll through the
DTV Setup features until
Ch. Install is highlighted.
Press CURSOR
>
followed by CURSOR
A or V until
you see AutoLock
highlighted.
Press CURSOR > to
enter the AutoLock
mode.
"Password " will
appear.
Press CURSOR >
followed by the
NUMERIC buttons on the
remote control to enter
the access code. 01!1
is the default. The first
time you enter the code,
Incorrect will appear on
the screen. Enter the same
code again. Correct will
be displayed. Now can
proceed to block channels.
Note : When you are in Digital
Mode you can only
AutoLock Digital
Channels.
IMai n A
O Picture
o Sound
o Fealures
e Inst_Jl
IDTV Setup * I
_ Channel Edit
o Digital Audio Weak Dig Sig
o Timer AutoLock
•> Closed Caption Fact Ch Reset
Ernerg Alert
[Ch Install _ t
Channel Edit
_ Password
_ Fact CH Beset Incorrecti
I Ch Instal[ I
O Channel Edit
o Weal( Dig Sig
_ Password
o Fact CH Reset Correct
Block Channelj _
I I
I i"_in " ]
o Picture
Timer
o Sound AutoLock
Iv Features _* {Active Control
o Instal[
[Ee_t ...... - ]
* Timer Access Code
[_ Autokock ]_ xxxx
_) Active Control
Incorrect
[Eeat .... ]
o Time New Code
[_"Autokock ]_
* Active Control
0 Setup Code
CleaxAll
o Block All
O Movie Rating
*_TV Rating
--NUMERIC
Press MENU button on
the remote control to
display the onscreen menu.
Press CURSOR A or
V to scroll through the
onscreen menu until you
see Features highlighted.
Press CURSOR > to
display the Features
menu.
Press CURSOR
A or v
repeatedly until you
see AutoLocl(
highlighted.
Press CURSOR > to
enter the AutoLock
mode.
"Access Code " will
appear.
Using the NUMERIC
buttons on the remote
control enter the access
code. 0111 is the default.
The first time you enter
the code, Incorrect will
appear on the screen.
Enter the same code again.
You will be prompted to
enter a new code.
Use the NUMERIC
buttons
on the remote
control enter the access
code of your choice.
Enter the same code a
second time to confirm
it. Once the new code is
confirmed, the AutoLock
menu will appear. You can
now access the functions
available in the menu.
Note : When you are in Analog
Mode you can only AutoLock
Analog Channels.
21