Table of Contents
Advertisement
Available languages
Available languages
IMPORTANT
NOTE TO INSTALLER
Please read the following instructions carefully before installing the washer.
These instructions should be retained for future reference.
We recommend you hire a professional to install this washer.
Installation
flow chart
Selectinga
_
Removingthe shipping _
Connecting thewater
location
bolts (*Drumonly)
andthe drain
T
i
i
i ii
i
ii
i
Please
Adjusting the
_
poweringyour washing
check again
levellingfeet
machine
before
steps.
[
Yes
DOes
yourwasher
haveexcess vibration
or noise?
Running a Calibration mode
(RefertOthe following
_
Finish the
installation
No
description)
STEP 1
Removing
the Shipping
Bolts
Before using your washer, you must remove all shipping bolts from the
back of the unit.
1, Loosen all the bolts with the supplied wrench.
2, Slide the bolt and spacer up and remove the bolt with the spacer
through the hole in the rear wall of your washer. Repeat for each
bolt.
3, Cover the holes with the supplied Bolt Hole Covers (See page 13).
4, Keep the shipping bolts and spacers for future use.
STEP 2
Selecting
a Location
_
Before you install your washer, make sure the location:
Has a hard, level surface
Is away from direct sunlight
Has adequate ventilation
Will not freeze (tempuratures are never below 32 °F or 0 °C).
Is away from heat sources such as oil or gas
Has enough room for the power cord.
Doesn't have any carpeting that will obstruct ventilation openings.
Hnstalling your washer 17
Advertisement
Table of Contents
