Blomberg DWT 59500 SS Installation Manual page 16

will damage the dishwasher's water inlet valve so if any such operation is needed, keep the
heat source min. 7 7 / 8 " (200mm) away from the dishwasher's water inlet valve.
• There should not be any sharp bends in the water line that may restrict the water flow.
• Teflon tape or pipe tread compound must be used for sealing the connection. Before
connecting the copper water supply line to the dishwasher, flush it with hot water to clear any
foreign material.
Notice :
After connections are made turn on the water supply to check for leaks.
7.1.4 ELECTRICAL CONNECTION
WARNING
• Make sure the voltage and frequency listed on the data plate correspond with the
household electrical supply. This data must correspond to prevent injury and machine
damage. Consult a qualified electrician if in doubt.
• Only connect the dishwasher to the mains when all installation and plumbing work is
complete.
• Do not use any extension cord or portable outlet device to connect the dishwasher to
a power supply.
• The power-supply receptacle for the appliance shall be installed in a cabinet or on a
wall adjacent to the undercounter space in which the appliance is to be installed.
• The access hole of the supply cord to the installation compartment must be smooth
and rounded and it must be large enough for the attachment plug to pass through. The
longest dimension of the opening shall not be more than 1,5" (38 mm).If the partition is
metal, it needs to be covered with an edge protector.
• Care must be taken when the appliance is installed or removed, to reduce the
likelihood of damage to the power-supply cord.
7.1.5 GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of a malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a path of least resistance for electric current. This
appliance is equipped with a cord having an equipment-grounding conductor and a grounding
plug. The plug must be plugged into an appropriate outlet that is installed and grounded
in accordance with all local codes and ordinances. This appliance must be connected to a
grounded metal, permanent wiring system, or an equipment-grounding conductor must be run
with the circuit conductors and connected to the equipment-grounding terminal or lead on the
appliance.
WARNING
• Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or service representative if you are
in doubt whether the appliance is properly grounded. Do not modify the plug provided
with the appliance, if it will not fit the outlet, have a proper outlet installed by a
qualified electrician.
7.1.3 WATER SUPPLY CONNECTION
Water supply may be connected to the dishwasher
in one of two ways:
• With metal braided hose.
• With copper tubing.
CAUTION
• Hot water supply line: Use minimum 3/8" O.D.
copper tubing or metal braided dishwasher supply
line.
• Temperatures required for soldering and sweating
14
USA