Table of Contents
Advertisement
Installing the Transmission Filters
1.
Apply a thin coat of the specified hydraulic fluid
to the rubber seal of the new filters; refer to
Transmission Fluid Specification (page
2.
Turn the filter clockwise until rubber seal
contacts the filter adapter, then tighten the filter
an additional 2/3 to 3/4 turn
3.
Remove the vent plug at each transmission.
Adding Transmission Fluid
1.
Remove cap from the expansion tank, add the
specified transmission fluid to the tank until
fluid comes out of the transmission vent, and
install the plug; refer to
Specification (page 46)
Transmission Fluid Level (page
2.
Repeat step
1
until fluid comes out of the vent of
the other transmission, and install the plug.
3.
Torque the vent plugs to 20 N·m (180 in-lb).
4.
Continue to adding the specified transmission
fluid until it reaches the FULL COLD line on
the expansion reservoir; refer to
Checking the Transmission Fluid Level (page
46).
5.
Raise the rear of machine up and support with
jack stands (or equivalent support) just high
enough to allow the drive wheels to turn freely.
CAUTION
Raising the machine for service
or maintenance relying solely on
mechanical or hydraulic jacks could be
dangerous. The mechanical or hydraulic
jacks may not be enough support or may
malfunction allowing the machine to fall,
which could cause injury.
Do not rely solely on mechanical
or hydraulic jacks for support. Use
adequate jack stands or equivalent
support.
6.
Start the engine and move the throttle control
ahead to 1/2 throttle position. Disengage the
parking brake.
46).
(Figure
57).
Transmission Fluid
and
Checking the
46).
Figure 56
in
WARNING
The engine must be running and the drive
wheels must be turning so motion control
adjustment can be performed. Contact
with moving parts or hot surfaces may
cause personal injury.
Keep your fingers, hands, and clothing
clear of rotating components and hot
surfaces.
7.
With the engine running, slowly move the
directional control in both forward and reverse
directions (5 to 6 times). Check the oil level, and
add oil as required after shutting off the engine.
It may be necessary to repeat step
is purged from the system. Air is purged from
the transaxle when it operates at normal sound
levels and moves forward and reverse smoothly
at normal speeds.
8.
Shut off the engine, remove the key, engage
the parking brake, and wait for all moving part
to stop.
9.
Remove the jack stands and lower the rear of
machine.
10.
Reset the transmission-oil maintenance
reminder; refer to
Maintenance Reminder (page
Resetting the Transmission-Oil
Maintenance Reminder
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
Note:
You must engage the parking brake to
reset the maintenance reminder.
2.
Cycle the key switch between the
and the
position 6 times within 8 seconds.
OFF
The Service Transmission screen displays and
flashes
(Figure
Service Transmission Screen
3.
Press down the multi-function switch.
47
7
until all air
Resetting the Transmission-Oil
47).
31).
RUN
58).
Figure 58
position
g212118
Advertisement
Table of Contents
