Vcr And Cable Box - Sony GRAND WEGA KDF-42WE655 Operating Instructions Manual

VCR and Cable Box
Before connecting a
cable box, see "Using
CableCARD" on page 56.
Use this hookup if:
Your cable TV company scrambles some channels, but not all of them
(pay channels vs. regular cable channels) and you need to use a cable
box.
You want to enjoy the Twin View feature.
With this setup you can:
Use the LCD projection TV's remote control to change channels on
your cable box when the signal is scrambled. To program your Sony
remote control to operate your cable box, see "Programming the
Remote Control" on page 62.
Use the LCD projection TV's remote control to change channels on
your LCD projection TV when the signal is not scrambled. Your LCD
projection TV's tuner provides a better signal than the cable box.
Use the Twin View feature. (When all channels are routed through your
cable box, only one signal is sent to the LCD projection TV, so you
cannot use the Twin View feature.)
)i i i i i ii i ¸ i i ! i
Connect tile CATV cable to the single (input) jack of tile splitter.
Using a coaxial cable, connect one of tile splitter's two output jacks to
the LCD projection TV's CABLE jack.
Using a coaxial cable, connect the splitter's other output jack to the
cable box's input jack.
Using a coaxial cable, connect the cable box's output jack to the VCR's
RF input jack.
Using an A/V cable, connect the cable box's A/V output jacks to the
TV's A/V input jacks.
Using an A/V and S VIDEO cables, connect the VCR's AUDIO S
VIDEO OUT jacks to the LCD projection TV's AUDIO and S VIDEO
IN input jacks.
Using a coaxial cable, connect the VCR's RF output jack to the LCD
projection TV's VHF/UHF jack.
Run Auto Program, as described in "Setting Up the LCD Projection TV
Channel List" on page 58.
_ Toview scrambled channels, tune the LeD projection TV to the channel
the cable box is set to (usually channel 3 or 4) and then usethe cable
box to switch channels.
40