True GDM-10F Installation Manual page 18

Light Cover Installation for GDM-10F & GDM-12F
REQUIRED TOOLS
• none
- IMPOR - IMPOR T T ANT - ANT -
- IMPOR - IMPOR T T ANT - ANT -
Before installing lamp cover Before replacing light cover
turn cabinet on and wait until it turn cabinet on and allow it to
reaches temperature. reach temperature.
STEP 1
Locate rubber gasket behind lamp holder
mounted to evaporator housing. (See
Image 1).
STEP 2
Fit the bottom edge of the lamp cover
into the bottom groove of the rubber
gasket and rotate upwards while
working the edges into the rest of the
rectangular groove. (See Images 2-3).
(slide fingers underneath top edges of
rubber gasket and push rubber over the
top lip of the lamp shield)
STEP 3
Be sure lamp cover is seated properly in
rubber gasket.
- NO TE -
- NO TE -
If cabinet is turned off and - IMPOR T ANT -
- IMPOR T ANT -
Before replacing light cover interior allowed to warm up
turn cabinet on and wait until it lamp cover may become loose
and require reinstallation. reaches temperature.
Follow directions above.
16
16
INST ALLA TION / OPERA
INST ALLA TION / OPERA
............ www.truemfg.com ............
............ www.truemfg.com ............
True Food Service Equipment, Inc.
True Food Service Equipment, Inc.
TION INSTRUCTIONS
TION INSTRUCTIONS
1
2
3
Rubber Gasket
Lamp Holder
Lamp Cover
16
16