Table of Contents
Advertisement
INST
INST
INSTALLING OPTIONAL CASTORS ON GDM-10 AND
GDM-12 MODELS
Final Location
A. Place styrofoam corners behind cooler for
cushion and carefully tilt unit on it's back.
B. Remove the louvered grill by removing four
phillips-head screws.
C. Remove the four bolts from the skid with an
adjustable wrench, and locate the four castors.
Castors are placed inside cooler, within the bubble
wrap.
D. Install one castor in each of the four female
threaded areas as indicated.
NOTE: Two out of the four castors are
designated with an "F" for front. These are
provided with hand-brakes. Position these
castors in FRONT of the unit.
E. When all castors have been threaded fully,
replace grill and lift unit; positioning it into its final
location.
F. Ensure that the two front castors are positioned
FORWARD as illustrated and locked down with the
hand-brakes.
WARNING:
Unit may tip forward if procedure "F" is not
strictly followed.
G. Units final location should be adequately
ventilated. Conditions where heat exceeds 100ºF
require an exhaust fan.
H. Ensure that the drain hose for hoses are
positioned in the pan.
I. Free plug and cord from inside the lower rear of
the cooler (Do Not Plug In.)
WARNING:
Warranty is VOID if ventilation is insufficient.
J. The unit should be placed close enough to the
electrical supply so that extension cords
are NEVER used.
8
8
ALLA
TION / OPERA
ALLA
TION / OPERA
............ www.truemfg.com ............
............ www.truemfg.com ............
True Food Service Equipment, Inc.
True Food Service Equipment, Inc.
TION INSTRUCTIONS
TION INSTRUCTIONS
WARNING:
Compressor warranties are void if the unit is
more than 6 1/2ft. (1.98m) from plug-in
connection.
K. Proper leveling of your TRUE cooler is critical to
operating success. Effective condensate removal
and door operation will be effected by leveling.
Adjust castors or add shims
POSITIONING OF THE
CASTOR IS CRITICAL.
ORIENT THE CASTOR IN
THE FORWARD POSITION
AS SHOWN
8
8
Hide quick links:
Advertisement
Table of Contents
