Sony M-425 Operating Instructions Manual page 5

To Press or slide
Stop recording asa
Start recording during @ during piayback (the unit
playback becomes in the recording mode)
Review the portion just Push up 44CUE/PREVIEW
recorded toward PREVIEW during the
recording. Release the button at the
point to start playback.
Pause recording Slide «t=PAUSE in the direction
of the arrow. The BATT (M-425/
527V) or REC/BATT (M-627V/
677V /727V) lamp goes off.
Take out a cassette as
Notes
Select the 2.4 cm tape speed for recording, if you play back the
recorded tape with another unit. Otherwise, the sound quality
may be R
Be careful not to press the microphone forcibly. Otherwise, the
microphone will be damaged and cause noise.
Notes on VOR (Voice Operated Recording) (M-527V/
627V/677V/727V only)
©The VOR system depends on the environmental conditions. If
you cannot get the desired results, set VOR to OFF.
© When you use the system in a noisy place, the unit will stay in
the recording mode. If the sound is too soft, on the contrary,
the unit will not start recording. Set VOR to H (high) or L (ow)
depending on the conditions.
To monitor the sound
Connect the earphone (not supplied) to EAR jack. The
monitor volume is fixed.
To prevent a cassette from being accidentally
recorded over
Break out and remove the cassette tabs. To reuse the
cassette for recording, cover the tab hole with adhesive
tape.