Pioneer DC-Z75 Operating Instructions Manual page 22

TIMER PLAYBACK
(Use tuner for timer setting.)
* A compact disc, ca tte deck, Gr a radio broadcast cam be used
instead of an alarm clock
© The current settings will appear again at the time set with the timer
© Timer playback begins everyday at the same time as tong as the timer
playback mode is not turned off
* During timer playback, to receive a desired station, first program the
channel frequency into STATION CALL button, and perform station
cail before setting the timer. If you do not do this, LAST is displayed
in the display section, and you will return to the station you were
previously listening to
Tape playback:
® Timer playback is possible with a cassette tape loaded in Deck |
Compact disc playback:
* The disc is played from the beginning when the timer turns the power
on,
{Timer setting example] (See Fig. [11] )
Set after switching power ON
Setting WAKE-UP 1 to receive FM 103.00 MHz (9 CH) between 7:15
and 8:00.
(Use the same procedure when using WAKE-UP 2.)
1, Tune into FM 103.00 MHz (9 CH} with STATION CALL
2. Press SET button and then (within 5 seconds) press WAKE-UP 1
button.
3. Use TUNING/TIMER ''~'" (DOWN) and "' + '' (UP) buttons to set
the wake up hour and minutes.
4. Press SET button.
* When you press the SET button, the time after one hour is
displayed in the display section (in this case, 8:15)
To leave the OFF time as it is, press the SET button. To change
the OFF time, perform the following procedure.
5. Use TUNING/TIMER ''-'' (DOWN) and "+ °' (UP) buttons to set
the turn off hour and minutes.
6. Press SET button.
{To activate the timer}
7. Turn power off,
* When timer playback operates, if the specified settings make
playback impossible (there's no CD in the disc tray, no cassette
tape is loaded, the TUNED indicator isn't fit at the tuned
frequency}, the input selector searches CD, TAPE, and TUNER,
and automatically switches to a source that provides sound.
When CD or TAPE has been set to TIMER, although none is actually
set, or when TUNER has been set and the TUNED indicator is not lit,
the unit will automatically search tor a sound source and play it back.
22
< ARB 1349 >
[ To change timer settings
* Repeat the procedure from the beginning to change settings
| If you make a mistake while setting the timer wl
* After inputting ail the timer settings, repeat the timer setting procedure
from the beginning
| Turning timer on and off : |
After inputting the timer settings, check the tuner display to confirm
which timer is on. The one that is lit (WAKE-UP [1] or [2]}) is the one
that will be executed. If you press a WAKE-UP button (1 or 2) to turn
off the indication, then the timer will not operate.
However, since the
settings remain stored in memary, you can press the button again to
reactivate the timer
NOTE: