Yamaha 33 1980 Owner's Manual page 31

Table of Contents

Advertisement

Y33 4-8
(8) Propeller Shaft Packing Gland:
When the engine Is running and In gear, there should be a few drops of water coming out of
the gland or else the packing locknuts are too tight and will burn up.
A drop of sea water every 10 ~ 20 seconds is standard, so adjust the locknuts.
At moorage, you may tighten the iocknuts to stop the leakage BUT DO NOT FORGET TO
ADJUST THE LOCKNUTS BEFORE YOU START THE ENGINE.
Replace the packing at least once a year.
Be sure you get SQUARE CUT WAX IMPREGNATED FLAX PACKING, of 4.8 mm/3/16 inch
and that It Is NOT WOUND AROUND THE SHAFT but cut to form three single rings which are
"stacked" on the shaft so that the cuts are staggered.
(9) Periodicai Replacement:
Every 1 year
Gland packing
Every 2 years
Fuel filter hose
Fuel supply line
Fuel return line
Exhaust rubber hose
Stern tube rubber hose
Every 3 years
Fuel tank
(10) MORSE Single Lever Control, Adjustment of:
A tag Is attached to the control lever and important instructions are printed on it. For your
convenience I will repeat these Instructions here:
FOR THE OWNER
IMPORTANT INSTRUCTIONS
This control system has been adjusted at the factory. However, due to changes in engine per
formance it may be necessary to re-adjust it after the break-in period, according to the in
struction on the reverse side.
1. Disconnect both control cables at the engine and adjust engine for smooth Idle. Set the
Idle stop for recommended Idle speed.
2. Place control head hand lever in Forward Detent. Adjust the terminal on the throttle
cable until It aligns with hole In carburetor throttle arm. Replace terminal and lock with
cotter pin.
3. Place control head hand lever at neutral detent. Place outdrive or transmission shift lever
In neutral position. Adjust the terminal on the shift cable until it aligns exactly with the
outdrive shift lever and re-connect the cable.
4. When control is properly adjusted, engine speed will remain at Idle when control head
hand is moved from Neutral to Forward or Reverse positions.

Advertisement

Table of Contents
loading

Table of Contents