Table of Contents
Advertisement
Y-33 4-5
4-2. STARTING ENGINE:
4-2-1. ELECTRICAL STARTING:
(1) Pull out the engine warm-up knob under the control lever and put the control lever in the "half
speed" position.
NOTE:
BEFORE STARTING MOTOR, MAKE SURE THIS CONTROL IS IN NEUTRAL
POSITION.
With Control In Neutral Position, knob can be pulled out — this will allow clutch to re
main In neutral while control lever can be moved to obtain desired starting throttle.
(2) Turn the switch key to "ON" position. (The warning buzzer will sound.)
(3) Press the starter button to start the engine. As soon as the engine starts, remove your finger
from the button.
(4) Move the control lever back to the Idle position and let the engine warm up for at least five
minutes.
-KEY WITCH
neutral
FWD
ASTERN
C4
-FUEL SHUT-OFF
KNOB
"-CLUTCH DISENGAGE KNOB
O /-xO
^ZZ.) OIL
, WATER
STARTER BUTTON^
O
I
I
BLOWER
Fig. 27
-FUEL GAUGE
Fig. 28
NOTE: 1) Do not run the starter motor for more than 10 seconds at a time.
Should the engine fall to start, wait for about 30 seconds before operating the starting
motor again.
2) Do not turn the battery switch or key switch off while the engine Is running.
3) Be sure to check that the charging light and the oil pressure and cooling water warning
lights go off.
4) Check that the cooling water Is coming out of the exhaust on the transom.
4-2-2. HAND STARTING:
(1) Turn the battery switch to "1" or "2" position.
(2) Pull out the engine warm up knob and place the control lever In the "HALF" position.
(3) Turn the switch key to "ON" position.
(4) Disengage the decompression lever and turn the starting handle vigorously 5 ~ 6 times.
(5) When sufficient momentum has been obtained, release the decompression lever and turn the
starting handle firmly.
Advertisement
Table of Contents
