Steps
1. Place the I/O board on the palm-rest and keyboard assembly.
2. Align the screw holes on the I/O board to the screw holes on the palm-rest and keyboard assembly.
3. Replace the two (M2x3.5) screws that secure the I/O board to the palm-rest and keyboard assembly.
4. Connect the fingerprint-reader board cable to the connector on the I/O board and close the latch (if applicable).
5. Connect the I/O board power cable to the connector on the I/O board and close the latch.
Next steps
1. Install the
base
cover.
2. Install the
SD
card.
3. Follow the procedure in
Display assembly
Removing the display assembly
CAUTION:
The information in this section is intended for authorized service technicians only.
CAUTION:
The maximum operating angle for the display-panel hinge is 135 degrees.
82
Removing and installing Field Replaceable Units (FRUs)
After working inside your
computer.