Pioneer SX-311R Operating Instructions Manual page 12

LISTENING TO BROADCASTS USING
PRESET TUNING
ress the POWER switch to the ON position. 1. Press the POWER switch to the ON position.
TE: 2. Press the STATION CALL button into which the
sure to turn the TAPE 2 MONITOR button OFF when listening desired station has been preset.
. TUNER, it will switch to the TUNER function automatically if
Set the BAND selector to either FM or AM. one of the STATION CALL buttons is pressed.
Tuning can be performed simply and accurately following the
Tune in the desired station. above procedure.
See the section "DIRECT ACCESS TUNING' for information on r :
reception using the Direct Access Tuning mode. 3. Adjust the volume with the VOLUME control and
See the section 'AUTO TUNING" for information on reception the tone with the GRAPHIC EQUALIZER controls.
using the Auto Tuning mode.
See the section "MANUAL TUNING" for information on recep- NOTE:
ion using the Manual Tuning mode. The contents of the STATION CALL button will be preserved for
In addition to station frequencies, the FM MODE (AUTO/MO-
severai days, even if the receiver power cord is unplugged.
NO) can also be preset.
If a preset station has been erased, preset it again.
FUNCTION and/or POWER switching. To recall, use BAND selec-
» press the STATION CALL button into which you tor buttons.
wish to preset the station.
Press the STATION CALL button while the MEMORY indicator
is flashing (about 5 seconds).
Use the STATION CALL buttons (*1 — #9, *0) to select a
preset channel. One press selects the 1 — 10 range, two press-
es 11 — 20, and three presses 21 — 30.
Example] If you press button [ + 3 ] :
nce - STATION 3
wice ~ STATION 13
hree times - STATION 23
ress a STATION CALL button within two seconds.
hen the display stops flashing, the station is preset.
Do not press buttons while the display is still Hashing.
_8. Repeat steps 2 to 5 to preset additional stations.
A total of 30 AM and FM stations may be preset. When you store
anew preset, it takes the place of the previously stored station (if
any).
14
<ABB1357 >