Sony Hyper HAD SPT-M124 Operating Instructions Manual page 3

emission limits.
AVERTISSEMENT
Afin d'eviter tout risque d'incendie ou d'electrocution, ne
pas exposer cet appareil a la pluie ou a I'humidite.
Afin decarter tout risque d'electrocution, garder le coffret
ferme. Ne confier I'entretien de I'appareil qu'a un personnel
qualifie.
ADVERTENCIA
Para prevenlr el riesgo de incendios o de electrocucion, no
exponga la unidad a la lluvia ni a la humedad.
Para evitar descargas electricas, no abra la unidad. En
caso de averia, solicite el servicio de personal cualificado
unicamente.
DC: For auto iris lenses controlled by DC signals
VIDEO: For auto iris lenses controlled by video signals
Note
When the auto iris lens selection switch is set to VIDEO, "hunting" may
occur. If this occurs, use the LEVEL IVH adjustment screw on the lens
to change the incident light level. When adjusting the incident light level,
set the ALC (Automatic Light Control) adjustment screw to Av.
O
Lens connector (4 pin socket)
Supplies power and control signals to an auto iris lens.
0
Lens mount
Use to mount an appropriate C-mount or a CS-mount lens. To attach a
C-mount/CS-mount lens, turn the focal length adjustment ring to the
appropriate position. The factory setting is CS mount.
Rear
□
O V-PHASE adjustment screw (SPT-M124/MI 24CE/M128CE)
Use to adjust the vertical phase of cameras synchronized by line lock.
0
CCD-IRIS ON/OFF switch
When using a manual iris lens, set the CCD-IRIS switch to "ON" to
automatically adjust the sensitivity according to the incident light
conditions. When using an auto iris lens, set this switch to "OFF."
0
BLC (Back Light Control) adjustment screw
Use to compensate for backlight conditions when using a manual iris
lens (when CCD-IRIS ON/OFF switch is set to "ON") or a DC controlled
auto iris lens.
This screw cannot be used when a video signal controlled auto iris lens
is mounted.
0
VIDEO OUT connector (BNC-type)
© AC 24 V screw terminals (SPT-M124/MI24CE)
Connect to an external power supply of AC 24 V.
DC 12 V screw terminals (SPT-M122CE)
Connect to an external power supply of DC 12 V.
0 LEVEL adjustment screw
Use to compensate for the video level when using a manual iris lens
(when CCD-IRIS ON/OFF switch is set to "ON") or a DC controlled auto
iris lens.
Note
This screw cannot be used when a video signal controlled auto iris lens
is mounted.
0 Ground terminal (screw type) (SPT-M124/MI 24CE)
0 Power cable (SPT-M128CE)
Connect to an AC power supply of 220 V to 240 V.