Table of Contents
Advertisement
Steps
1. Align the screw holes on the assembly-inner frame with the screw holes on the system board and the palm-rest assembly.
2. Replace the twelve screws (M2x3) that secure the assembly-inner frame to the palm-rest assembly.
3. Connect the speaker cable to the system board.
4. Route the speaker cables through the routing guides on the palm-rest assembly.
5. Route the antenna cables through the routing guides on the palm-rest assembly.
Next steps
1. Install the
WLAN
card.
2. Install the
4G WWAN card
3. Install the battery.
4. Install the
base
cover.
5. Install the
SIM
card.
6. Follow the procedure in
Touchpad
Removing the touchpad
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
SIM
card.
3. Remove the
base
cover.
4. Remove the battery.
74
Removing and installing Field Replaceable Units (FRUs)
or
5G WWAN
card, as applicable.
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
